TY - GEN
T1 - Investigating the mechanical properties of 3D printed components
AU - Al Khawaja, Huda
AU - Alabdouli, Haleimah
AU - Alqaydi, Hend
AU - Mansour, Aya
AU - Ahmed, Waleed
AU - Al Jassmi, Hamad
N1 - Publisher Copyright:
© 2020 IEEE.
PY - 2020/2
Y1 - 2020/2
N2 - Additive manufacturing (AM) has acquired an increasing interest from industrial, academic, and research fields in the last few decades. One of the AM techniques that is overgrowing and gripping more attention is Fused Deposition Modeling (FDM). 3D printed parts with FDM are being considered in replacing traditionally manufactured parts made with traditional materials. Hence, comes the need for understanding the mechanical behavior of printed parts to evaluate its eligibility for any given application. However, knowledge established is lacking information about 3D printing materials mechanical properties. From here comes the aim of this paper, which is to investigate the compression properties of PLA 3D printed samples. Furthermore, to examine the consistency of mechanical behavior over duplicated 3D printed samples. Specimens would be 3D printed by the FDM technique under the same 3D print conditions to minimize and -or if possible- eliminate the impact of unwanted factors on compressive properties of the material.
AB - Additive manufacturing (AM) has acquired an increasing interest from industrial, academic, and research fields in the last few decades. One of the AM techniques that is overgrowing and gripping more attention is Fused Deposition Modeling (FDM). 3D printed parts with FDM are being considered in replacing traditionally manufactured parts made with traditional materials. Hence, comes the need for understanding the mechanical behavior of printed parts to evaluate its eligibility for any given application. However, knowledge established is lacking information about 3D printing materials mechanical properties. From here comes the aim of this paper, which is to investigate the compression properties of PLA 3D printed samples. Furthermore, to examine the consistency of mechanical behavior over duplicated 3D printed samples. Specimens would be 3D printed by the FDM technique under the same 3D print conditions to minimize and -or if possible- eliminate the impact of unwanted factors on compressive properties of the material.
KW - 3D printed parts
KW - Fused deposition modeling
KW - Mechanical properties
UR - http://www.scopus.com/inward/record.url?scp=85087443742&partnerID=8YFLogxK
UR - http://www.scopus.com/inward/citedby.url?scp=85087443742&partnerID=8YFLogxK
U2 - 10.1109/ASET48392.2020.9118307
DO - 10.1109/ASET48392.2020.9118307
M3 - Conference contribution
AN - SCOPUS:85087443742
T3 - 2020 Advances in Science and Engineering Technology International Conferences, ASET 2020
BT - 2020 Advances in Science and Engineering Technology International Conferences, ASET 2020
PB - Institute of Electrical and Electronics Engineers Inc.
T2 - 2020 Advances in Science and Engineering Technology International Conferences, ASET 2020
Y2 - 4 February 2020 through 9 April 2020
ER -